how to configure only one interface as the source port while keeping the management interface separa

charles898cabal — Sat, 11 Jan 2025 09:38:51 GMT

Hi everyone,

I’m working with an EXOS switch (5320) and I’m trying to configure only one interface as the source port for traffic mirroring, while using another interface as the management interface. Currently, I have both the mirror port and the source port configured on the same interface, but I need to isolate them and set only one interface as the source port.

Can someone guide me on how to configure only one interface as the source port while keeping the management interface separate? I want to make sure I’m following best practices for this type of setup.

Thanks in advance for your help!

Re: how to configure only one interface as the source port while keeping the management interface se

OscarK — Mon, 13 Jan 2025 07:42:27 GMT

You can configure the source IP from which the mirror is send.

configure mirror <mirror name> from <tab>
auto-source-ip Automatically use source IP address of egress VLAN used to reach remote IP (Default)
<source_ip_address> Use specified local IPv4 address for encapsulated mirrored packets

topic Re: how to configure only one interface as the source port while keeping the management interface se in ExtremeControl

how to configure only one interface as the source port while keeping the management interface separa

Re: how to configure only one interface as the source port while keeping the management interface se