topic RE: S-Series hard coded port isn't working in ExtremeSwitching (EOS)

S-Series hard coded port isn't working

Matt_Dillion — Tue, 24 Jul 2018 23:23:00 GMT

After hard coding a port on my S-Series S1 switch the port will not work. I have hard coded the port using the following commands in order; set port duplex ge.1.46 full, set port speed ge.1.46 1000, set port negotiation ge.1.46 disable. I have tried using multiple pieces of equipment but the port never comes up.

RE: S-Series hard coded port isn't working

Zdeněk_Pala — Wed, 25 Jul 2018 03:21:00 GMT

What is on the other end? How it is configures? Before your changes, was there a link? If you create loop (with spanning tree enabled by default) do you get link?

RE: S-Series hard coded port isn't working

Matt_Dillion — Wed, 25 Jul 2018 17:11:00 GMT

When using my laptop I have tried manually setting the speed/duplex setting to 1000/Full. I have also tried creating a loop and tried plugging the port into another Enterasys switch with the port set to auto-negotiate.

RE: S-Series hard coded port isn't working

Matt_Dillion — Wed, 25 Jul 2018 20:17:00 GMT

Well, I received an email update from Extreme notifying me that Curtis Parish replied to my problem, however I do not see that reply here. Nevertheless, if you are reading this Curtis, I disabled negotiation on the port in question. Command executed "set port negotiation ge.1.46 disable".