topic I would like to confirm that it is not possible to apply acl on egress interface on version IMG: 12.0.3.16 XGM2-1 (summit x450e-48p) in ExtremeSwitching (EXOS/Switch Engine)

I would like to confirm that it is not possible to apply acl on egress interface on version IMG: 12.0.3.16 XGM2-1 (summit x450e-48p)

Anonymous — Tue, 25 Aug 2015 17:55:00 GMT

X450e-48p.18 # configure access-list printerpol ports 15 ?
Execute the command
ingress Acls applied to ingress

I am applying this policy for a printer which is shared on the network (only selected IP addresses should be able to access the printer)

I was thinking of applying the following policy on the port, but its being applied to the ingress interface so its not of any use:

entry iprule1 {if {
source-address 10.2.5.134/32 ;
destination-address 10.2.5.199/32 ; -------printer
}
then {
permit ;
}
}
entry iprule2 {
if {
source-address 0.0.0.0/0 ;
destination-address 10.2.5.199/32 ;
}
then {
deny;
}
}

Is there a way to do this ?

RE: I would like to confirm that it is not possible to apply acl on egress interface on version IMG: 12.0.3.16 XGM2-1 (summit x450e-48p)

OscarK — Tue, 25 Aug 2015 18:22:00 GMT

As you can see no egress ACL possible, but you could apply this ACL ingress on all ports, that would do the trick.

RE: I would like to confirm that it is not possible to apply acl on egress interface on version IMG: 12.0.3.16 XGM2-1 (summit x450e-48p)

Anonymous — Tue, 25 Aug 2015 18:22:00 GMT

Thankyou. It works!! 🙂