topic RE: how can i enable gui in X460 r X440 in ExtremeSwitching (EXOS/Switch Engine)

how can i enable gui in X460 r X440

zain_mallick — Fri, 22 Apr 2016 12:05:00 GMT

how can i enable GUI in X440 X460....i m creating vlan and give ip and enable web hhtp..but not open gui interface...? plz guide me...this is my code

create vlan name
configuration vlan name tag name
configuration vlan name ipaddress 192.168.1.225 255.255.255.0
configruatoin vlan name add ports 4 untageed
enable web http

this is my code which i run in X460 summit extreme ,but not showing GUI interface...
and when i connect wire with port ,port light is not on...

RE: how can i enable gui in X460 r X440

Karthik_Mohando — Fri, 22 Apr 2016 12:57:00 GMT

Hi Zain,

Can you make sure the port is not disabled.

You can use the command "show ports no-refresh" and see if the port state is enabled.

if not then use the command "enable ports " or all

RE: how can i enable gui in X460 r X440

zain_mallick — Fri, 22 Apr 2016 14:53:00 GMT

yes sir i enable all ports..

RE: how can i enable gui in X460 r X440

Karthik_Mohando — Fri, 22 Apr 2016 16:09:00 GMT

Hi Zain,

Thanks and did that solve the issue were you able to get the GUI now?

RE: how can i enable gui in X460 r X440

Patrick_Voss — Fri, 22 Apr 2016 17:26:00 GMT

Hello Zain,

Can you access the switch via telnet? using the same ip address you are using for the web interface? If not I would recommend consoling into the switch again and check the port status using the "show port command. If it is working correctly it should say enabled and active.

Check this out and let us know what you see. Pasting the outputs can help as well.

RE: how can i enable gui in X460 r X440

Drew_C — Thu, 28 Apr 2016 19:40:00 GMT

Are you still having trouble with this, Zain?

RE: how can i enable gui in X460 r X440

zain_mallick — Thu, 28 Apr 2016 19:40:00 GMT

thanx sir....no sir...