topic RE: AVB disabled after reboot in ExtremeSwitching (EXOS/Switch Engine)

AVB disabled after reboot

Jeff_Woodford — Wed, 24 Oct 2018 03:24:00 GMT

I have a X440-G2-24t-GE4, I have installed the AVB licence using the CLI, then set up a IP for using the web browser chalet control. I enabled the AVB ports in chalet and clicked save. but when the switch is power cycled/rebooted the AVB ports are disabled upon reboot. i have to go back into the AVB config and enable them again.

any clues as to why this is happening?

RE: AVB disabled after reboot

Ronald_Dvorak — Wed, 24 Oct 2018 13:55:00 GMT

Try....
- enable ports via chalet
- save config via CLI
.... does that work ?

What software version is running and what web browser is used, have you tried it with another PC/browser.

RE: AVB disabled after reboot

Jeff_Woodford — Tue, 06 Nov 2018 01:18:00 GMT

I tried a different browser and same issue. config not saved via chalet after reboot.

I found this from the Biamp website and used the CLI and Putty:

To enable AVB on all ports, enter the following commands:

disable flow-control rx-pause ports all

disable flow-control tx-pause ports all

enable avb

enable avb port all

disable edp port all

save configuration

this worked and th config was saved after a reboot.

I have to say the Extreme Networks website and support documentation and user guides are a nightmare to find the right information and massively over complicated