topic Re: Extreme 210 POE service port down in ExtremeSwitching (EXOS/Switch Engine)

Extreme 210 POE service port down

Justin_Chan — Thu, 21 Feb 2019 15:54:36 GMT

Dear expert,

How to bring up the service port for the Extreme 210 POE switch?

Extreme 210) #show serviceport

Interface Status............................... Down
IP Address..................................... 10.241.0.21
Subnet Mask.................................... 255.255.252.0
Default Gateway................................ 10.241.0.1
IPv6 Administrative Mode....................... Enabled
Configured IPv4 Protocol....................... None
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Burned In MAC Address.......................... 00:04:96:A1:8D:95

Thanks in advance

BR// JC!

Re: Extreme 210 POE service port down

Ronald_Dvorak — Thu, 21 Feb 2019 16:26:29 GMT

You connect a cable&device to the serviceport (=Management Port) of the switch.

Re: Extreme 210 POE service port down

Justin_Chan — Thu, 21 Feb 2019 16:50:32 GMT

Hi Ronald,

Thanks for your help.
The link is up when I connect the PC to this port.
Also, I can browse into the POE to check the configuration.

I need to connect 14 POE in four rooms, I don't want to each room to check the POEs.
Is it possible that I use the browser to connect this POE without connecting the service port.
What should I do?

BR// Justin

Re: Extreme 210 POE service port down

Ronald_Dvorak — Thu, 21 Feb 2019 17:18:52 GMT

The service port is for out of band mgmt = https://en.wikipedia.org/wiki/Out-of-band_management

Looks like you like to use in band mgmt.
Start by removing the IP from the service port (I assume you'd like to use that IP to access the switch).

Here a example from my switch....

set IP for access:
network protocol none
network parms 172.25.25.154 255.255.255.0 172.25.25.254

in case you don't use the default VLAN you'd need to set the VLANID for mgmt. e.g. 100 in my example
network mgmt_vlan 100

-Ron