topic Re: show port configuration no-refresh in ExtremeSwitching (EXOS/Switch Engine)

show port configuration no-refresh

jasonlsch — Tue, 18 Dec 2018 04:29:10 GMT

Hi,

ran: show port configuration no-refresh

Port Configuration
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
6:40 VR-Default E A ON AUTO 1000 AUTO FULL SYM UTP
6:41 VR-Default E R ON AUTO AUTO UTP
6:42 VR-Default E A ON AUTO 1000 AUTO FULL NONE UTP
6:43 VR-Default E A ON AUTO 100 AUTO FULL SYM UTP
6:44 VR-Default E A ON AUTO 100 AUTO FULL SYM UTP
6:45 VR-Default E A ON AUTO 1000 AUTO FULL SY/ASY UTP *
6:46 VR-Default E R ON AUTO AUTO NONE *
6:47 VR-Default E A ON AUTO 1000 AUTO FULL SY/ASY UTP *
6:48 VR-Default E A ON AUTO 1000 AUTO FULL SYM UTP *

What does the asterick (*) mean?

Thanks

Re: show port configuration no-refresh

Drew_C — Tue, 18 Dec 2018 04:45:46 GMT

The legend is printed at the bottom of the command, but in the case of the *, its meaning may be a little unclear. This is for software redundant ports, where an RJ45/Copper port shares port numbering with an SFP/Fiber port. You can set the priority for those and whether the link should prefer the fiber connection or the copper one.

Legend:

code:

# show port config no-refresh
[snip]
================================================================================
> indicates Port Display Name truncated past 8 characters
Link State: A-Active, R-Ready, NP-Port Not Present, L-Loopback
Port State: D-Disabled, E-Enabled, L-License Disabled
Media: !-Unsupported, $-Unlicensed
Media Red: * - use "show port info detail" for redundant media type
Flow Cntrl: Shows link partner's abilities. NONE if Auto Neg is OFF

Re: show port configuration no-refresh

jasonlsch — Tue, 18 Dec 2018 05:00:54 GMT

Thank you