OSPF Multiple Area - Network not announced in 2nd area

Come — Wed, 02 Oct 2019 22:47:20 GMT

Hello,

Here is a simple schema of my network architecture :

We have two ospf zone, backbone which announce all company sites, and new zone which will announce site subnets to Edge.

I have created a 2nd area (0.0.0.10). Two equipements are part of this area :

A summit X450
A Cisco Meraki

Here is the ospf configuration on X450 :
"enable ospf
configure ospf restart grace-period 300
enable ospf export direct cost 1 type ase-type-1
enable ospf export static cost 50 type ase-type-1 tag 50
create ospf area 0.0.0.10
configure ospf add vlan interco area 0.0.0.10
configure ospf vlan interco priority 0
configure ospf add vlan other_sites area 0.0.0.0
configure ospf vlan other_sites priority 0
"
Here is the ospf configuration on Meraki :

Problem is i don't have any routes announced in this new area. I have captured traffic, all i can see are hello packets.
Adjacency seems to be done as i have this in X450
"Neighbor ID Pri State Up/Dead Time Address Interface
BFD Session State
==========================================================================================
1.1.1.1 0 2WAY /DROTHER 00:01:25:20/00:00:00:09 10.0.0.1 INTERCO_M
None
"

I can't see any DR and BDR elected, maybe there is the problem :
"Area: 0.0.0.10 Type: Normal
Router Id: 1.1.1.1
Spf Runs: 16 Num ABR: 1 Num ASBR: 1 Num LSA: 18 LSA Chksum:0xd911b
Interfaces:
IP addr Ospf State DR IP addr BDR IP addr
10.0.0.1 /24 E ODR 0.0.0.0 0.0.0.0
10.0.1.1 /24 D DOWN 0.0.0.0 0.0.0.0
10.0.2.1 /25 D DOWN 0.0.0.0 0.0.0.0
Inter-Area route Filter:
External route Filter:Configured Address Ranges:
"
But when i try to set priority to force DR, i have this :
"configure ospf vlan interco priority 10
Error: This command cannot be executed at the current license level.

Configuration failed on backup Node, command execution aborted!
"
License level is advanced edge.
Version is 22.5.1.7

Anyone has an idea ?

Thanks,
Regards,
Côme

Re: OSPF Multiple Area - Network not announced in 2nd area

Drew_C — Tue, 08 Oct 2019 21:14:17 GMT

Hi Côme, I believe this is a limitation of the Advanced Edge License.
Here's the Feature License Guide for Advanced Edge.
Here is the same information for the Core license.

-Drew

topic OSPF Multiple Area - Network not announced in 2nd area in ExtremeSwitching (EXOS/Switch Engine)

OSPF Multiple Area - Network not announced in 2nd area

Re: OSPF Multiple Area - Network not announced in 2nd area