topic Re: Hi , i have a problem whith ACL!!! Help me please!!! in ExtremeSwitching (EXOS/Switch Engine)

Hi , i have a problem whith ACL!!! Help me please!!!

Alexey_shaverne — Tue, 21 Apr 2020 12:53:25 GMT

I HAVE A PROBLEM WITH CONFIGURING acl TO THE PORT. I have summit X440G2-48p-10G4 separately and also have a stack of 5 slots. On the switch, the setting is applied, but not on the stack, says a syntax error, but the code is the same everywhere. And when typing the "check policy" command, it answers Policy file check successful. What can be wrong ? The firmware is the same there and there)

This is stack

This is Switch

This is log of the Stack

Re: Hi , i have a problem whith ACL!!! Help me please!!!

slewfoot2xm — Tue, 21 Apr 2020 19:25:03 GMT

I know when setting up syslogging, you have to add the slot # to the commands to tell it which switch in the stack it’s supposed to be applied to. It’s probably a similar requirement.

Re: Hi , i have a problem whith ACL!!! Help me please!!!

Necheporenko__N — Wed, 22 Apr 2020 18:42:44 GMT

Hello Alexey,

Check if your stack has enough hardware resources to install this ACL.

show access-list usage asl-slice port <port_#>

Best Regards,

Nikolay