https://community.extremenetworks.com/t5/extremeswitching-exos-switch/upmprofile/m-p/80537#M19971 UPM profile is launch if one or port event (PortlinkstateUp) is caused.<BR /> UPM profile set standard var (related just to UPM profile, so Param_0,Param_1 extc,exct...<BR /> Question is:<BR /> Is possible read the port(s) status and fix these as variable and then use it in the Upm's script?<BR /> If yes, where I can take the value/parameters about their state?<BR /> <BR /> I need to make an expression in wich condition is:<BR /> If port A,B,C, status is Up, than enable port D<BR /> <BR /> Of course UPM filter is setted onto just Port A,B,C (for launch the Upm profile) Tue, 20 Aug 2019 13:37:40 GMT cyrano1978 2019-08-20T13:37:40Z https://community.extremenetworks.com/t5/extremeswitching-exos-switch/upmprofile/m-p/80537#M19971 UPM profile is launch if one or port event (PortlinkstateUp) is caused.<BR /> UPM profile set standard var (related just to UPM profile, so Param_0,Param_1 extc,exct...<BR /> Question is:<BR /> Is possible read the port(s) status and fix these as variable and then use it in the Upm's script?<BR /> If yes, where I can take the value/parameters about their state?<BR /> <BR /> I need to make an expression in wich condition is:<BR /> If port A,B,C, status is Up, than enable port D<BR /> <BR /> Of course UPM filter is setted onto just Port A,B,C (for launch the Upm profile) Tue, 20 Aug 2019 13:37:40 GMT https://community.extremenetworks.com/t5/extremeswitching-exos-switch/upmprofile/m-p/80537#M19971 cyrano1978 2019-08-20T13:37:40Z