Cannot get node in stack to pass data

Lane_Messer — Thu, 18 Jul 2019 02:22:19 GMT

We have a stack of three switches of the Summit X450-G2.

One failed and was replaced with the same one. Went through the usual process of replacing using enable stacking and assigning a number.

We have it listed as a standby along with slot 3. 1 being the master. However, slot 1 and 3 have internet access while slot 2 does not and is not receiving anything from the DHCP. Everything shows up fine with show stacking and stacking detail.

Slot 1 versions:
Primary 16.1.0.1.8
Secondary 21.1.1.4

Slot 2:
Primary: 22.6.1.4
Secondary: 21.1.1.4

Slot 3:
Primary: 16.1.0.1.8
Secondary: 21.1.1.4

Again, slot 1 and 3 have internet connection. Slot 2 can see the computers along with the other nodes, but will not provide an IP or internet connectivity.

Re: Cannot get node in stack to pass data

Sarah_Seidl — Thu, 18 Jul 2019 22:58:53 GMT

What if you do a synchronize slot 2 which will not only synchronize the slot but reboot as part of the process (slot 2) it to see if that clears things up?

topic Cannot get node in stack to pass data in ExtremeSwitching (EXOS/Switch Engine)

Cannot get node in stack to pass data

Re: Cannot get node in stack to pass data