topic Re: Firmware Question on x440g2 Stack in ExtremeSwitching (EXOS/Switch Engine)

Firmware Question on x440g2 Stack

DanoN3t — Wed, 31 Aug 2022 11:17:01 GMT

I updated our firmware from 23x to 32.7 over the weekend and am having issues with DHCP bootrelay, devices on one vlan are not receiving correct IP addresses. At this point, I just want to downgrade to the old firmware, which is still on the primary partition. When I look at Extreme's webpage with instructions for this, it gives two commands: use image <PARTITION_NAME> and: use image <partition_name> slot <slot#>. Since I have three x440g2's in a stack should I run the second command which includes the slot and will it update all three switches? Or would the first command, use image <PARTITION_NAME> be fine?

I appreciate you all.

Re: Firmware Question on x440g2 Stack

markus_of — Wed, 31 Aug 2022 11:38:19 GMT

if all stack members have the same image version on the primary and secondary partition .

example:

Card Partition Installation Date Version Name Branch
------------------------------------------------------------------------------
Slot-1 primary Sat Aug 6 01:09:43 MEST 2022 31.7.1.4 summitX-31.7.1.4.xos 31.7.1.4
Slot-1 secondary Tue Aug 17 01:10:03 MEST 2021 31.3.1.3 summitX-31.3.1.3-patch1-5.xos 31.3.1.3-patch1-5

Slot-2 primary Sat Aug 6 01:14:41 MEST 2022 31.7.1.4 summitX-31.7.1.4.xos 31.7.1.4
Slot-2 secondary Tue Aug 17 01:15:15 MEST 2021 31.3.1.3 summitX-31.3.1.3-patch1-5.xos 31.3.1.3-patch1-5

Slot-3 primary Sat Aug 6 01:10:18 MEST 2022 31.7.1.4 summitX-31.7.1.4.xos 31.7.1.4
Slot-3 secondary Tue Aug 17 01:10:30 MEST 2021 31.3.1.3 summitX-31.3.1.3-patch1-5.xos 31.3.1.3-patch1-5

then you can say easy "use image primary" or "use image secodary" .. over the master... all stack members boots the same image.

Re: Firmware Question on x440g2 Stack

DanoN3t — Wed, 31 Aug 2022 11:56:43 GMT

The all have the same image version. Thank you for your answer and quick response!

I'm going to try, use image primary, afterhours tonight.