https://community.extremenetworks.com/t5/extremeswitching-exos-switch/default-interface-configuration/m-p/15093#M56 Hello,<BR /> <BR /> Does anyone know if Exos has a command to remove all configuration from a given interface like Cisco has the "default interface"<BR /> <BR /> Regards<BR /> Gonçalo Reis Fri, 23 Mar 2018 21:04:00 GMT GONÇALO_NUNO_CO 2018-03-23T21:04:00Z https://community.extremenetworks.com/t5/extremeswitching-exos-switch/default-interface-configuration/m-p/15093#M56 Hello,<BR /> <BR /> Does anyone know if Exos has a command to remove all configuration from a given interface like Cisco has the "default interface"<BR /> <BR /> Regards<BR /> Gonçalo Reis Fri, 23 Mar 2018 21:04:00 GMT https://community.extremenetworks.com/t5/extremeswitching-exos-switch/default-interface-configuration/m-p/15093#M56 GONÇALO_NUNO_CO 2018-03-23T21:04:00Z https://community.extremenetworks.com/t5/extremeswitching-exos-switch/default-interface-configuration/m-p/15094#M57 Not sure if there is a specific command but there is a way to do this... We have on occasion turned a multi-vlan trunk port into an edge single vlan port and what we do is create a port share using the port we need to reset to zero configuration as a member of the port share.<BR /> <BR /> so if port 2 is your port you want to wipe you create a port share using un-used port as the master and port 2 as a member and it will blank port 2 out as it now needs to have same configuration as the master port. After you create the share you can tear it apart an now port 2 has no configured vlans...<BR /> <BR /> This method does not effect any traffic on the vlans or services you were trying to cleat off port 2. <BR /> <BR /> this is for physical interface configurations only and not for ip interfaces.. Fri, 23 Mar 2018 21:39:00 GMT https://community.extremenetworks.com/t5/extremeswitching-exos-switch/default-interface-configuration/m-p/15094#M57 EtherMAN 2018-03-23T21:39:00Z