topic RE: Summit X440-48 creating an LACP to a Dell S600 in ExtremeSwitching (EXOS/Switch Engine)

Summit X440-48 creating an LACP to a Dell S600

TS_MTL — Tue, 30 Jun 2015 01:07:00 GMT

Trying to create an LACP to a Dell S6000.

49 Default E A 10G FULL
50 Default E A 10G FULL

On the summit, when I look on the dell it's up 10G full duplex also.

dc-mgnt02.7 # enable sharing 2 grouping 40-50 lacp

Error: System cannot support Load Sharing among port media types with different maximum speed

I get the above EVERY single time. I've tried auto neg, forcing specific speeds and duplex. Nothing seems to work.

On the S6000 I've got it setup to use LACP I just need to configure the summit now.

Has anyone else run into this issue?

RE: Summit X440-48 creating an LACP to a Dell S600

StephenW — Tue, 30 Jun 2015 01:11:00 GMT

It looks like the command your using might be wrong. To add port 49 and 50 in a share group use the command below, and make sure the Dell side has LACP enabled

# enable sharing 49 grouping 49-50 lacp

GTAC knowledge reference:
https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summit-stack-or-BlackDiamond-switches

RE: Summit X440-48 creating an LACP to a Dell S600

TS_MTL — Tue, 30 Jun 2015 01:14:00 GMT

That was it! thanks!