topic RE: What do I need to have to stack X460-48P switches in ExtremeSwitching (EXOS/Switch Engine)

What do I need to have to stack X460-48P switches

BILL_REITLER — Wed, 24 May 2017 22:50:00 GMT

What do I need to have to stack X460-48P switches

RE: What do I need to have to stack X460-48P switches

Jefferson_Lemos — Wed, 24 May 2017 22:57:00 GMT

Hi Bill, below have a link where you can find the all informations about stacking on Exos:

https://gtacknowledge.extremenetworks.com/articles/Q_A/Where-Can-I-Find-the-EXOS-Stacking-Tool

Att

RE: What do I need to have to stack X460-48P switches

Andrew_Imam — Wed, 24 May 2017 23:00:00 GMT

Hi Bill,

In addition to the Stacking Tool that Jefferson mentioned, please use the steps outlined in the following GTAC Knowledge base article to configure and enable stacking on your X460-48p switches:

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-create-stack-with-Summit-X460-48p-a...

Please let us know if you have any questions.
Thank you.

Best regards,
Andrew

RE: What do I need to have to stack X460-48P switches

Jefferson_Lemos — Wed, 24 May 2017 23:00:00 GMT

Andrew, Thanks for your support !!!

RE: What do I need to have to stack X460-48P switches

Larry_Kunz — Wed, 24 May 2017 23:04:00 GMT

The stacking tool, which Jefferson referenced, is very helpful. In addition, here's a link to a page from the Hardware Installation Guide with specific stacking considerations for X460 switches.

Larry Kunz
Information Development
Extreme Networks

RE: What do I need to have to stack X460-48P switches

BILL_REITLER — Wed, 24 May 2017 23:15:00 GMT

Thanks guys that was the info I needed. Guess I am ordering some hardware.