topic RE: Ports LEDs have to be lighting in ExtremeSwitching (EXOS/Switch Engine)

Ports LEDs have to be lighting

Alexandr_P — Wed, 30 Sep 2015 11:25:00 GMT

Hi, all!

Have not so trivial question )))

We have some conference with Extreme stand.
I whant that Summit switches power on and all port LEDs have to be lighting.
Is there some commands or cycle LED tests to do this?

Thank you!

RE: Ports LEDs have to be lighting

OscarK — Wed, 30 Sep 2015 11:40:00 GMT

What kind of switch ? Some switches make the port led flash when the port is disabled.

RE: Ports LEDs have to be lighting

Alexandr_P — Wed, 30 Sep 2015 11:42:00 GMT

Summit X670, X460-G2 and C35 controller

RE: Ports LEDs have to be lighting

OscarK — Wed, 30 Sep 2015 11:46:00 GMT

These do not flash when disabling the ports.
You can connect all ports to eachother with lots of cables but that is not what you want probably.
I cannot think of any other method.

RE: Ports LEDs have to be lighting

Alexandr_P — Wed, 30 Sep 2015 11:48:00 GMT

When run diag ext - testing ports and their flashing )))

RE: Ports LEDs have to be lighting

Karthik_Mohando — Wed, 30 Sep 2015 11:55:00 GMT

For the X670 and X460 i guess you can try the command

"enable led locator {timeout [seconds | none]} {pattern [alternating | flash-all |
high-to-low | scanner]} {slot [ slot | all ]}"

and see if that helps

RE: Ports LEDs have to be lighting

eyeV — Wed, 30 Sep 2015 11:55:00 GMT

That's nice!

RE: Ports LEDs have to be lighting

Alexandr_P — Wed, 30 Sep 2015 11:55:00 GMT

Thank you, Karthik!

That's what I need.
Most cool mode is alternate.

RE: Ports LEDs have to be lighting

Drew_C — Wed, 30 Sep 2015 11:55:00 GMT

Just note the

code:

timeout none

flag so that it won't turn off after a while. I believe 5 minutes is the default.