topic RE: enterasys xp 2400-256 in ExtremeSwitching (Other)

enterasys xp 2400-256

Mark1 — Thu, 06 Oct 2016 16:32:00 GMT

when the router boots up and you run the show command the Ethernet ports show as being disabled, however when you plug in an Ethernet cable the port comes up. is there a way to enable the ports, and change the admin state, as the show port status say admin state down.

RE: enterasys xp 2400-256

Bastian_Sprotte — Thu, 06 Oct 2016 16:42:00 GMT

hello,
in the config mode you can use the command "show"
this now will show the config with line numbers #.
to remove commands you enter "negate #" and "save active".
now the config remove the line numbers.
regards

RE: enterasys xp 2400-256

Mark1 — Thu, 06 Oct 2016 16:42:00 GMT

Thanks for the reply, if i do a show command, line 1 for example has :- port disable et.1.1 im looking to enable this port.

RE: enterasys xp 2400-256

Bastian_Sprotte — Thu, 06 Oct 2016 16:42:00 GMT

use the command
negate 1
save active

this should cause the disabled port will be enabled
-

RE: enterasys xp 2400-256

Mark1 — Thu, 06 Oct 2016 16:42:00 GMT

Thanks bastian ... this was doing my head in lol. if i do a show port status on et.1.1 link state is up and admin state is up now.