topic RE: Hi all! What is different between LACP or a static algorithm??? Please advice. in ExtremeSwitching (Other)

Hi all! What is different between LACP or a static algorithm??? Please advice.

Paul11 — Sat, 29 Nov 2014 23:34:00 GMT

What is different between LACP or a static algorithm?

enable sharing port 47 grouping 47,48 L2 or L3

Kindly advise.

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

PARTHIBAN_CHINN — Sat, 29 Nov 2014 23:48:00 GMT

Hi Lacp is for interoperability between multiple vendors. Lacp is Ieee standard. Lacp can more than 8 links which can be standby Static lag has its own limitations based on vendor. The above config u made is static lag

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

Paul11 — Sat, 29 Nov 2014 23:48:00 GMT

Hi PARTHIBAN,

Thanks, I want to create Link aggregation between 2 Extreme Switch. Now is only 1 link connected. What is the best solution? There will be any downtime or network loop may happend?

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

PARTHIBAN_CHINN — Sun, 30 Nov 2014 00:22:00 GMT

You should have the same lag configured on the peer switch. Once that's done u can connect both the links. If there is a misconfiguration then there is possibility of loop . But it's just one liner. Also u should add necessary vlans to the master port 47 to carry traffic

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

Paul11 — Sun, 30 Nov 2014 00:22:00 GMT

Thanks PARTHIBAN,

Can you please provide the command to check after the LAG configuration done at both switches?

Is it load sharing using 2 Link or only using Master port?

And how can we prevent if Loop occur. Unplug the link and remove config? Or it will still creating a Network loop?

Please advice.

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

Paul11 — Sun, 30 Nov 2014 00:22:00 GMT

hi how to add necessary vlans to the master port 47 to carry traffic?

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

PARTHIBAN_CHINN — Sun, 30 Nov 2014 12:48:00 GMT

Show sharing Then use show port 47,48 utilisation/statistics This should tell u if the tragic is load shared.

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

Paul11 — Sun, 30 Nov 2014 12:48:00 GMT

And how can we prevent if Loop occur. Unplug the link and remove config? Or it will still creating a Network loop? thanks.

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

PARTHIBAN_CHINN — Sun, 30 Nov 2014 13:21:00 GMT

When we have right config we need not worry about loop. But for precautions we can enable elrp. Elrp can shutdown ports when loop is detected

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

Paul11 — Tue, 02 Dec 2014 00:26:00 GMT

Thanks PARTHIBAN,

RE: Hi all! What is different between LACP or a static algorithm??? Please advice.

Weda — Fri, 30 Oct 2015 19:56:00 GMT

Hello Folks, Could you please explain, what is the major difference between static and dynamic LAG? Is that only, dynamaic LAG supports different vendor switches and Static LAG supports only for same vendor switches ? Thank you very much in advance.