topic Re: Configuration for a Summit 200 Series and VMware teaming in ExtremeSwitching (Other)

Configuration for a Summit 200 Series and VMware teaming

Ricardo — Tue, 12 Feb 2019 18:58:53 GMT

Hello everyone.

I have an environment with one vmware server with 2 NICs configured as teaming connected to a switch. It seems that all traffic is going only through one of the ports.

If a do a cable test on the switch (a 220-48t-10GE4) it says always cable fail in one of the ports. Of course I tested the cables and the ports of the server and everything is fine.

I guess I need to configure the 220 properly.

In other switches, summit 400 series for example is very easy, you can use this comand: enable sharing grouping algorithm address-based L3_L4

But with 220 series this command does not works.

Do you know the equivalent to this command in a 220 series?

Thanks in advanced.

Re: Configuration for a Summit 200 Series and VMware teaming

Ronald_Dvorak — Tue, 12 Feb 2019 20:08:56 GMT

https://documentation.extremenetworks.com/200_admin/downloads/GUID-8CFAE6C4-0265-4888-89B7-F4115C828809.pdf

Page#214 = PortChannel

Re: Configuration for a Summit 200 Series and VMware teaming

Ronald_Dvorak — Tue, 12 Feb 2019 20:11:30 GMT

https://documentation.extremenetworks.com/200_commands/downloads/GUID-D60A18E3-9453-4EF5-A1D6-F96235169BC5.pdf

Page#382 for the CLI commands

Re: Configuration for a Summit 200 Series and VMware teaming

Ricardo — Tue, 12 Feb 2019 20:32:22 GMT

Thank you.

I'll take a look