topic How to configure loopback interface for VSP 7200? in ExtremeSwitching (VSP/Fabric Engine)

How to configure loopback interface for VSP 7200?

jwumcp — Tue, 09 Jun 2020 04:39:50 GMT

Hello, I did some research but I cannot seem to find out how to configure loopback interface on VSP 7200. Can someone please provide some advice? I know how to do it in Cisco or EXOS , but not sure how to do this in VOSS.

Thank you in advance.

Re: How to configure loopback interface for VSP 7200?

EXTR_Paul — Tue, 09 Jun 2020 04:58:17 GMT

interface loopback 1 <where “1” is the Loopback Id>

ip address 1 172.16.40.1/32

Re: How to configure loopback interface for VSP 7200?

jwumcp — Tue, 09 Jun 2020 05:16:39 GMT

Thank you for the quick response. I just noticed that VOSS use the term CLIP for the similar idea which I did not notice initially.

Re: How to configure loopback interface for VSP 7200?

EXTR_Paul — Thu, 11 Jun 2020 02:33:56 GMT

Correct. Circuitless IP or CLIP or LoopBack interface. The terms are interchangeable.