https://community.extremenetworks.com/t5/extremeswitching-vsp-fabric/default-no-access-to-4550t-via-gui-console/m-p/92025#M1871 I have a problem which has been going on for over a month now and is really starting to become a serious issue for me . it is about 4550T-PWR switche.i have no information about IP and password .in other hand I am unable to access the switch via the web interface even if I am directly connected to it with a cat5 cable and set my NIC to be on the same IP subnet as the documented switch IP address.<BR /> next I tried the console port.This is where it gets really frustrating. I have attached to the console port using every combination of cable I could find a suggestion for on the internet. I first used a straight through female to female serial cable on a USB/Serial adatpter without luck. In PuTTy and Hyper Terminal it seems to make a connection and does not time out,yet there is no text displayed on the screen. I have tried control+Y and various other key combinations to elicit some type of response but have come up empty handed.<BR /> <BR /> If anyone could please let me know of any other way either to access or to set this switch back to defaults. Mon, 13 May 2019 04:04:40 GMT farzaneh 2019-05-13T04:04:40Z https://community.extremenetworks.com/t5/extremeswitching-vsp-fabric/default-no-access-to-4550t-via-gui-console/m-p/92025#M1871 I have a problem which has been going on for over a month now and is really starting to become a serious issue for me . it is about 4550T-PWR switche.i have no information about IP and password .in other hand I am unable to access the switch via the web interface even if I am directly connected to it with a cat5 cable and set my NIC to be on the same IP subnet as the documented switch IP address.<BR /> next I tried the console port.This is where it gets really frustrating. I have attached to the console port using every combination of cable I could find a suggestion for on the internet. I first used a straight through female to female serial cable on a USB/Serial adatpter without luck. In PuTTy and Hyper Terminal it seems to make a connection and does not time out,yet there is no text displayed on the screen. I have tried control+Y and various other key combinations to elicit some type of response but have come up empty handed.<BR /> <BR /> If anyone could please let me know of any other way either to access or to set this switch back to defaults. Mon, 13 May 2019 04:04:40 GMT https://community.extremenetworks.com/t5/extremeswitching-vsp-fabric/default-no-access-to-4550t-via-gui-console/m-p/92025#M1871 farzaneh 2019-05-13T04:04:40Z