topic Re: Mirror to isid offset only working in tx mode on 5420 in ExtremeSwitching (VSP/Fabric Engine)

Mirror to isid offset only working in tx mode on 5420

JeanNoel — Wed, 24 Apr 2024 08:44:01 GMT

I'm using 5420 with Fabric Engine an i need to mirror ports to an isid.

I've been trying to setup this with several Fabric Engine releases (9.0.2 / 8.10.3 / 8.8 or 8.6) with no success:

if the port is in autosense mode and the i-sid attached to the port is a switched-uni, no trafic is mirrored at all. I read this is the normal behaviour.
if i set up a platform vlan with attached l2vsn and disable autosense on the mirrored port, manually puting it in the configured vlan, i will only get tx trafic on my monitoring node

I've been trying using acl/ace or mirror-by-port commands with the same result

mirror-by-port 1 in-port 1/48 monitor-isid-offset 153
mirror-by-port 1 mode both

filter acl 1 type inVsn matchType both

filter acl i-sid 1 2000
filter acl ace 1 1 name "rspan"
filter acl ace action 1 1 permit monitor-isid-offset 153

filter acl ace ethernet 1 1 ether-type eq ip
filter acl ace 1 1 enable

And on monitoring switch:

monitor-by-isid 1 monitor-isid-offset 153 egress-ports 1/16

I've set up mirroring on older switches (VSP4850 for example, running VOSS 7.1.10) using mirror-by-port command with the same offset and I have no issue in that case: i monitor both directions from this switch.

Has anyone experienced the same issue and/or managed to get mirroring to isid in both directions on 5420 with fabricEngine > 8.6

Thanks, regards

Jean-Noel

Re: Mirror to isid offset only working in tx mode on 5420

Marlon_Scheid — Wed, 24 Apr 2024 12:05:52 GMT

Hi Jean-Noel,

I faced the same issue on the 7520 and 5420. But did not open a GTAC case yet.

regards

Marlon

Re: Mirror to isid offset only working in tx mode on 5420

Ludovico_Steven — Wed, 24 Apr 2024 12:19:22 GMT

See https://documentation.extremenetworks.com/FABRICENGINE/SW/902/FabricEngineUserGuide/GUID-EABD677C-E041-454E-ABD2-E5AECE9369C6.shtml

"Incoming traffic that does not contain a VLAN tag is not mirrored into an I-SID if the offset ID is in the range 2 to 1000. It is mirrored to an I-SID only if the offset ID is 1."

This restriction only applies to VSP7400 and all Universal-hardware platforms 5x20,7x20
The older VSP platforms did not have this limitation.

Try changing the monitor-isid-offset to 1

Re: Mirror to isid offset only working in tx mode on 5420

JeanNoel — Thu, 25 Apr 2024 08:56:33 GMT

Thanks, I had missed the restriction. Indeed with offset to 1 it's fine.

Regards