nat-pat setting on enterasys xp 2400-256

Junior_Oliveira — Mon, 08 Jan 2018 03:21:00 GMT

I have an Enterasys X-Pedition 2400 256 and i'm trying to set a nat pat, but i couldn't make it work yet. I couldn't find enough resources to understand how to set pat on this model of switch so i've been just crashing my head on wall to accomplish it 😞
Could someone explain me how could i do it or give me some tips? Any help is welcome!

Below are the configurations i've tried so far. Where it should be a public IP i replaced by "pu.bl.ic.ip"

vlan create externa port-based id 2054
vlan create interna port-based id 2

vlan add ports et.2.8 to externa
vlan add ports et.2.(6-7) to interna

interface create ip en2 address-netmask 192.168.2.1/24 vlan interna up
interface create ip en8 address-netmask pu.bl.ic.ip/24 vlan externa up

acl lcl2 permit ip 192.168.2.0/24

ip add route 192.168.2.0/24 gateway 192.168.2.1
ip add route default gateway pu.bl.ic.254

dhcp scope2 define parameters address-netmask 192.168.2.1/24 gateway 192.168.2.1
dhcp scope2 define pool 192.168.2.2-192.168.2.3

nat set interface en2 inside
nat set interface en8 outside
nat create dynamic enable-ip-overload local-acl-pool lcl2 global-pool pu.bl.ic.ip

RE: nat-pat setting on enterasys xp 2400-256

Zdeněk_Pala — Mon, 08 Jan 2018 04:28:00 GMT

hmm impressive. nice to know someone is still using this historical product.

Try examples in documentation:

http://www.logan.com/ssr/xp9191/user.pdf page 359
good luck!

Z.

RE: nat-pat setting on enterasys xp 2400-256

Junior_Oliveira — Wed, 10 Jan 2018 21:39:00 GMT

Thanks, i could do it!

topic RE: nat-pat setting on enterasys xp 2400-256 in ExtremeSwitching (VSP/Fabric Engine)

nat-pat setting on enterasys xp 2400-256

RE: nat-pat setting on enterasys xp 2400-256

RE: nat-pat setting on enterasys xp 2400-256