topic RE: How to define Native Vlan to trunk port on voss VSP switches in ExtremeSwitching (VSP/Fabric Engine)

How to define Native Vlan to trunk port on voss VSP switches

Erhan_YILDIZ1 — Fri, 12 Oct 2018 18:14:00 GMT

Define Native Vlan on Voss

RE: How to define Native Vlan to trunk port on voss VSP switches

Erhan_YILDIZ1 — Fri, 12 Oct 2018 18:16:00 GMT

Hello, I need a cli command to do that. Could not find anything on cli guide about native vlan.
Thanks,
Best Regards

RE: How to define Native Vlan to trunk port on voss VSP switches

Martin_Sebek — Fri, 12 Oct 2018 18:17:00 GMT

Hello,

in the port configuration you have to setup default vlan and enable untagging that vlan.

For example for vlan 10:
default-vlan-id 10
untag-port-default-vlan enable

RE: How to define Native Vlan to trunk port on voss VSP switches

Erhan_YILDIZ1 — Fri, 12 Oct 2018 18:42:00 GMT

Hello Martin,

I couldn't test that for now but you are briallant.

Thanks,
Best Regards

RE: How to define Native Vlan to trunk port on voss VSP switches

Jongseok_Won — Sat, 13 Oct 2018 05:55:00 GMT

Hello, below is the Configuring the VLAN feature on a port using EDM.

1. On the Device Physical View tab, select a port or multiple ports.
2. In the Navigation tree, expand the following folders: Configuration > Edit > Port.
3. Click General.
4. Click the VLAN tab.
5. To perform tagging, select PerformTagging.
6. To discard tagged frames, select DiscardTaggedFrames.
7. To discard untagged frames, select DiscardUntaggedFrames.
8. To use the Untag Default VLAN feature, select UntagDefaultVlan.
Important:
Extreme recommends that you enable tagging on the port before you configure
UntagDefaultVlans.
9. Enter a default VLAN ID.
10. In the Classification area, select the types of VLAN to enable.
11. In the Classification area, select the Private VLAN port type. See Creating a private
VLAN on page 69 for more information.
12. Click Apply.
13. Click Close.