topic RE: XR600P power options in ExtremeWireless (IQE)

XR600P power options

terence_fleming — Wed, 08 Dec 2021 11:23:00 GMT

Hi Sam, thanks.

I find when I connect the XR600P Eth4 to either a 802.3at PoE injector or an X440 switch port the device does not boot. Is there a setting on the XR600P that needs to be changed to permit the injector or switch to recognise the XR600P as a device that can accept PoE power?

I am based in New Zealand. Should I reach out to Geoff Mason, or should I contact one of the Engineers in Australia?

Thanks

RE: XR600P power options

terence_fleming — Wed, 08 Dec 2021 11:28:00 GMT

Hi Sam

Forgot to mention - I also find that the power supply from an old BR200 can also power up the XR600P, even though it is rated at a lower output voltage than the XR600P power block. Would this be an option?

Thanks

On Wed, Dec 8, 2021 at 9:22 PM Terence Fleming <terence.fleming@thinkwireless.co.nz> wrote:

Hi Sam, thanks.

I find when I connect the XR600P Eth4 to either a 802.3at PoE injector or an X440 switch port the device does not boot. Is there a setting on the XR600P that needs to be changed to permit the injector or switch to recognise the XR600P as a device that can accept PoE power?

I am based in New Zealand. Should I reach out to Geoff Mason, or should I contact one of the Engineers in Australia?

Thanks

--
Terence Fleming
Mobile: 021 435 508
Email: Terence.Fleming@thinkwireless.co.nz

RE: XR600P power options

SamPirok — Fri, 10 Dec 2021 00:01:00 GMT

Hi Terrence, I've been trying to find a definite answer for you here, but so far I haven't had much luck. This would be something your local sales engineer can help you with, I've just sent a direct message with your local SE's contact info in case you want to reach out to them in the mean time. Thanks for your patience here.