topic RE: WS-AP3705i Console Port in ExtremeWireless (General)

WS-AP3705i Console Port

kouichi_ohtomo — Fri, 06 Mar 2015 16:06:00 GMT

We want to use AP3705i console port.
Can we configuration from console port of AP3705i? (IP, gateway, etc.)
to tell us ;
AP console port pin assignment , terminal setting

Regards,

RE: WS-AP3705i Console Port

Ronald_Dvorak — Fri, 06 Mar 2015 18:21:00 GMT

Hi, you'd set the following parameter via the console port to allow the AP to connect to the controller if you don't use an DHCP server...
- IP = cset ipaddr x.x.x.x
- subnetmask = cset ipmask x.x.x.x
- gateway = cset gateway x.x.x.x
- set controller IP = cset authip 1 x.x.x.x
to apply and save use..
- capply
- csave

The baudrate is 115200 - just use a the same console cable as you'd use for a router/switch.

RE: WS-AP3705i Console Port

kouichi_ohtomo — Fri, 06 Mar 2015 18:21:00 GMT

Thank you for reply.

We were able to confirm that it can be set from the console port.

However, there was the discovery of 2 points.

1, console cable, in the Cisco console, was not a Enterasys console.
2, It was required first to [cset dhcpc disable] command

** We have tested with firmware version "08.32.08.0002".

Regards,

RE: WS-AP3705i Console Port

juan_romero — Wed, 17 Aug 2016 01:23:00 GMT

Is there a way to confirm configuraration a "show configuration" command or something like that?

RE: WS-AP3705i Console Port

juan_romero — Thu, 18 Aug 2016 23:02:00 GMT

Thank you very much, I'll try the command.