https://community.extremenetworks.com/t5/extremewireless-general/sdn-network-with-enterasys-s-series-switches/m-p/36236#M1675 Greetings Rolf,<BR /> <BR /> My Product Management friends tell me we are supporting OF v1.3 as part of the 8.61 firmware release for S-Series coming in late February. This will be initially supported on the SSA180's and any fabric inserted in the S1-chassis. Based on customer feedback, we are considering extending support to the multi-slot S-Series chassis in a future release. Hope this helps!<BR /> <BR /> -Dan<BR /> <BR /> Wed, 13 Jan 2016 02:19:00 GMT Dan_Dulac 2016-01-13T02:19:00Z https://community.extremenetworks.com/t5/extremewireless-general/sdn-network-with-enterasys-s-series-switches/m-p/36235#M1674 We would<BR /> like to set up an SDN Network. A Controller (POX and OpenDaylight which runs on virtual environment (VM)) shall operate with Enterasys S-Series switches communicating with OpenFlow.<BR /> <BR /> We have already tested the controller’s functionality virtually using mininet. In mininet it can be specified that the controller is remote and the controller’s ip address (example):<BR /> <BR /> sudo mn --topo linear,3 --mac --controller remote,ip=192.168.57.129 --switch ovsk<BR /> <BR /> <BR /> <BR /> My questions are now:<BR /> <BR /> Can something similar be configured on the Enterasys S-Series switches (I haven’t seen something in the configuration manual)?<BR /> <BR /> Which Enterasys S-Series SW Version do we need at least for this SDN setup?<BR /> <BR /> Which OpenFlow Versions are supported?<BR /> <BR /> Tue, 15 Dec 2015 00:03:00 GMT https://community.extremenetworks.com/t5/extremewireless-general/sdn-network-with-enterasys-s-series-switches/m-p/36235#M1674 Rolf_Lanz 2015-12-15T00:03:00Z https://community.extremenetworks.com/t5/extremewireless-general/sdn-network-with-enterasys-s-series-switches/m-p/36236#M1675 Greetings Rolf,<BR /> <BR /> My Product Management friends tell me we are supporting OF v1.3 as part of the 8.61 firmware release for S-Series coming in late February. This will be initially supported on the SSA180's and any fabric inserted in the S1-chassis. Based on customer feedback, we are considering extending support to the multi-slot S-Series chassis in a future release. Hope this helps!<BR /> <BR /> -Dan<BR /> <BR /> Wed, 13 Jan 2016 02:19:00 GMT https://community.extremenetworks.com/t5/extremewireless-general/sdn-network-with-enterasys-s-series-switches/m-p/36236#M1675 Dan_Dulac 2016-01-13T02:19:00Z