topic RE: V2110 Configuration Upgrade failed in ExtremeWireless (Identifi)

V2110 Configuration Upgrade failed

Robert_Zdzieblo — Wed, 31 Aug 2016 13:59:00 GMT

During EWC V2110 upgrade from 09.21.05.0007 to 10.11.02.0032 I had following info: Aug 31 06:38:47 CEST 2016 V2110 Upgrading From Release 9_21 Aug 31 06:39:41 CEST 2016 Successfully Restored the Internal Configuration V2110:vnsmode:radius:NAC1# apply Exception: 'utf8' codec can't decode bytes in position 1-2: invalid continuation byte. (file=/usr/lib/python2.7/encodings/utf_8.py:16 function=decode) at /var/controller/images/bu_restore/rpm-upgrade-saved-configuration.cli(1) Aug 31 06:39:42 CEST 2016 Configuration Upgrade failed, Aborting the Process! Please contact your technical support I lost all my WLAN and VNS settings I had on my v9.21 controller. Anyone had similar issues when upgrading from 9.21.x to 10.11.x ? I am going to upgrade customer's EWC infrastructure and I don't want to configure all wireless settings from scratch. BEST REGARDS Robert

RE: V2110 Configuration Upgrade failed

Ronald_Dvorak — Wed, 31 Aug 2016 14:27:00 GMT

I haven't had any migration issues for a long time - you should open a ticket and provide the configuration so the guys could run the same upgrade with your config to see which line in the config forces the problem.

To the lost data I'd only say one word "Backup".
You should always do one before an upgrade and save it a external device.

But even if the upgrade failed the default upgrade option would be to generate a rescue image before the upgrade even start.
Load it back and all data is restored..... if you haven't disabled it which is not recommended.

RE: V2110 Configuration Upgrade failed

Robert_Zdzieblo — Wed, 31 Aug 2016 14:27:00 GMT

Sure, but both: rescue image and/or snapshot takes me back to my older image, which is not the right direction 

RE: V2110 Configuration Upgrade failed

Robert_Zdzieblo — Wed, 31 Aug 2016 14:27:00 GMT

One question: does rescue image downgrade reverts back APs fimrware version to match the EWC version ?

RE: V2110 Configuration Upgrade failed

Ronald_Dvorak — Wed, 31 Aug 2016 14:27:00 GMT

No, the rescue image has nothing to do with the AP image BUT during the tunnel setup between the AP/controller the AP will check the version.

If auto upgrade is enabled (default) then the AP will up/downgrade to the same version as the controller is running.

RE: V2110 Configuration Upgrade failed

Zdeněk_Pala — Sat, 10 Sep 2016 02:24:00 GMT

I would guess there are some special characters in your config somewhere. try to avoid that and upgrade again...