topic RE: V2110 - Unrecognized Command in ExtremeWireless (Identifi)

V2110 - Unrecognized Command

Justsomebodi — Tue, 29 Sep 2015 18:11:00 GMT

When trying to configure a V2110 at the below step in the initial configuration section i type

5 Enter the IP address for the appliance to the admin interface with the appliance
command:

EWC.enterasys.com:topology:Admin:l3# appliance address of appliance>

I get unrecognized command. Does anyoneone know why? I am using the 9.12.01.0067-1 as it's the only one that installed without an error.

RE: V2110 - Unrecognized Command

Doug — Tue, 29 Sep 2015 18:21:00 GMT

No issues that we know of. I've setup a few C35's without any problems via that wizard menu. Another alternative would be to follow this KB article...

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-V2110-physical-management-int...

Admin= Out of Band Management, no AP Registration.
ESA= Physical Port for Management and AP Registration

RE: V2110 - Unrecognized Command

Justsomebodi — Tue, 29 Sep 2015 19:36:00 GMT

It still complains about this bit

create "Management" physical 1 port esa0 untag 10.26.0.166/20

What should it be for a virtual c2110. a show l2ports has

esa0/esa1/admin

RE: V2110 - Unrecognized Command

Ronald_Dvorak — Tue, 29 Sep 2015 19:36:00 GMT

Could you attach a screenshot of the CLI commands that you use and the error message that you get...

RE: V2110 - Unrecognized Command

Ronald_Dvorak — Tue, 29 Sep 2015 19:44:00 GMT

Here a example to configure the IP 10.12.0.2/24 on the ESA0 port with untag VLAN 100 AND enable mgmt traffic = GUI access....

V2110# topology V2110:topology# create "ESA0" physical 100 port esa0 untag 10.12.0.2/24

V2110:topology# ESA0

V2110:topology:ESA0# l3

V2110:topology:ESA0:l3# mgmt enable

V2110:topology:ESA0:l3# apply

-Ron

RE: V2110 - Unrecognized Command

Gareth_Mitchell — Tue, 29 Sep 2015 20:22:00 GMT

Could you try it with a vlan other than 1, as Ron suggested, vlan 1 is an internal vlan?

Or you can change the internal vlan id

RE: V2110 - Unrecognized Command

Justsomebodi — Wed, 28 Oct 2015 17:47:00 GMT

Thanks guys for the replies. Ron's solution worked. My version of V-controller was very old.