topic Creating a toplogy for end users in ExtremeWireless (Identifi)

Creating a toplogy for end users

Saiprasad_Rao_R — Wed, 29 Jul 2015 17:26:00 GMT

I want end users to get ip address (from dhcp server) from the ssid i have created.

what all toplogies have to be created (planning for B@AP).

what tagging/untagging has to be done on
1) controller?
2) the switch port on which controller will be connecting?
3) on the switches to witch ap's get connected.

RE: Creating a toplogy for end users

Ronald_Dvorak — Wed, 29 Jul 2015 17:59:00 GMT

Hi, would you please be so kind and not create different posts to the same issue.

Everything was discussed in your other one....
https://community.extremenetworks.com/extreme/topics/difference-between-tag-and-untag-in-topology-cr...

I don't want to be rude but I'd STRONGLY recommend to get someone onsite to support you.

http://www.extremenetworks.com/partner-locator

It's not easy to design a network that big (from the information that you've provided so far) in a forum post without previous experience and a full unterstanding how the solution works.

Kind regards,
Ron

RE: Creating a toplogy for end users

Doug — Wed, 29 Jul 2015 18:02:00 GMT

Hello,

Have you taken a look at our "Wireless Getting Started Guide"? It should help point you in the right direction.

https://extranet.extremenetworks.com/downloads/Pages/dms.ashx?download=eecab97b-e22d-4683-ba3d-db674...

RE: Creating a toplogy for end users

Mohanakrishnan_ — Thu, 30 Jul 2015 18:35:00 GMT

I recommend the suggestions from Doug and Ron. The queries above are network level decisions and are not just controller configs. I would suggest make these design decisions with help of Partner.

For the above question : Assuming that VNS NonAuth topology traffic is B@AP, DHCP Server is in DMZ VLAN, Clients placed in Wireless VLAN, you can configure bootprelay in Extreme switches. Follow below link for more info : https://community.extremenetworks.com/extreme/topics/new_to_extreme_need_help_with_configuration

Since you are planning for B@AP you need to tag client VLANs in EWC, but needed to switchport connected to AP. In controller you need to configure B@AP topologies that will be pushed to APs.