https://community.extremenetworks.com/t5/extremewireless-identifi/bonding-eth0-error-couldn-t-find-a-slave-in-bond-that-can-be/m-p/44945#M3859 Having researched this error, it typically points to a hardware problem to where an RMA is needed. It would be recommended to open a case with GTAC to move forward. The AP-3965i has a one year warranty though we would also check the entitlement on the asset.<BR /> Sat, 17 Nov 2018 07:48:00 GMT Ty_Izzet 2018-11-17T07:48:00Z https://community.extremenetworks.com/t5/extremewireless-identifi/bonding-eth0-error-couldn-t-find-a-slave-in-bond-that-can-be/m-p/44944#M3858 I have an AP-3965i that will power up, but doesn't link to the switch and has the following output on the command line:<BR /> <BR /> bonding: eth0: Error: Couldn't find a slave in bond that can be used for ethtoolI can't find any documentation about this message and wonder if I have a bad AP. Any ideas?<BR /> <BR /> Sat, 17 Nov 2018 00:39:00 GMT https://community.extremenetworks.com/t5/extremewireless-identifi/bonding-eth0-error-couldn-t-find-a-slave-in-bond-that-can-be/m-p/44944#M3858 Doug_Hales 2018-11-17T00:39:00Z https://community.extremenetworks.com/t5/extremewireless-identifi/bonding-eth0-error-couldn-t-find-a-slave-in-bond-that-can-be/m-p/44945#M3859 Having researched this error, it typically points to a hardware problem to where an RMA is needed. It would be recommended to open a case with GTAC to move forward. The AP-3965i has a one year warranty though we would also check the entitlement on the asset.<BR /> Sat, 17 Nov 2018 07:48:00 GMT https://community.extremenetworks.com/t5/extremewireless-identifi/bonding-eth0-error-couldn-t-find-a-slave-in-bond-that-can-be/m-p/44945#M3859 Ty_Izzet 2018-11-17T07:48:00Z