topic Firmware Version 10.21 in ExtremeWireless (Identifi)

Firmware Version 10.21

Andre_Brits_Kan — Thu, 27 Oct 2016 02:06:00 GMT

Hi all

I have been following the launch of the new 3912 and 3916 AP's.
I am very excited about the new models.

I see the new AP's is launched with the new Ver 10.21 firmware.
Can we get access to the new firmware?
Under my downloads I only have access to ver 10.11...
If not do you have release notes available?

Thx

RE: Firmware Version 10.21

Alex15 — Thu, 27 Oct 2016 13:12:00 GMT

Hello Andre
FW 10.21 is not yet released. Not even internal.
You will see an update on this if you are registered to the WLAN info or just contact our GTAC and ask 4 early adoption.
Alex

RE: Firmware Version 10.21

hsachse — Thu, 27 Oct 2016 13:12:00 GMT

I need early access too and an AP3912i for use during a large site survey. I will open a GTAC case/request.

RE: Firmware Version 10.21

Ronald_Dvorak — Thu, 27 Oct 2016 13:16:00 GMT

I wonder whether the dimensions in the datasheet are correct because in the pictures it doens't look like that the AP3912 has equal hight/lenght.

Dimensions per datasheet = 8.46” x 8.46” x 2.2” (21.5 x 21.5 x 5.6 cm)

Regarding the software, I think it will take some more weeks till the AP is shipped to the end customer.

RE: Firmware Version 10.21

hsachse — Thu, 27 Oct 2016 13:16:00 GMT

Hello Ronald,

this Twitter post in the included link show some picture of the new AP:

https://twitter.com/Aliyoussef_/status/793211794093404160

RE: Firmware Version 10.21

Umut_Aydin — Mon, 31 Oct 2016 20:05:00 GMT

It should be 18.5 x 12.5 x 2.5 cm .
I will check if this get changed otherwise I will forward this for change.

Umut Aydin

RE: Firmware Version 10.21

Ronald_Dvorak — Mon, 31 Oct 2016 20:05:00 GMT

Thx

RE: Firmware Version 10.21

Andre_Brits_Kan — Tue, 01 Nov 2016 02:40:00 GMT

So a question regarding the new AP3912.
Will the Ethernet ports support B@HWC controller?
It will be a nice feature to be able to tunnel the ethernet connected devices to the controller.

Thx

RE: Firmware Version 10.21

Andre_Brits_Kan — Wed, 02 Nov 2016 16:47:00 GMT

Answering my own question, but Yes the Ethernet ports will allow Bridge@HWC.

Thx