topic cluster config update rejected in ExtremeWireless (WiNG)

cluster config update rejected

Jose_LV — Fri, 09 Mar 2018 19:24:00 GMT

Hello
I have a cluster with 2 rfs 6000. Since yesterday, this event appears:
Err: cluster config update rejected - master does not accept full config.
And any configuration made in the active rfs is not replicated in the standby rfs

RE: cluster config update rejected

aholden — Fri, 09 Mar 2018 20:25:00 GMT

Please check how your CLUSTER was formed. Are you forming it with both I/P and VLAN. If so, remove the CLUSTER VLAN.

If not the issue, you will need to submit a case .

RE: cluster config update rejected

Jose_LV — Fri, 09 Mar 2018 20:25:00 GMT

Hello Andy
Thanks for the reply.
The cluster was already formed. And the vlan cluster is already disabled.

RE: cluster config update rejected

Daniel_Mejia — Sat, 10 Mar 2018 00:52:00 GMT

Hi Jose,

Please reference the following KCS article on WiNG cluster configuration.

How to configure a cluster in ExtremeWiNG Controllers on WiNG5.4 and above

RE: cluster config update rejected

Timo1 — Sat, 10 Mar 2018 04:17:00 GMT

Hi,
do you have configured different priority? If you don't configure this and have new configuration on booth sides, that can be the problem.

RE: cluster config update rejected

Jose_LV — Sat, 10 Mar 2018 04:17:00 GMT

Hi Timo
The priorities are configured with different values in the two rfs.
The rfs and the cluster were working well for a long time until the restart that was made yesterday.

the show cluster member command shows the two rfs and the show cluster status command shows one rfs in active and another in stanby in the cluster

RE: cluster config update rejected

Jose_LV — Mon, 12 Mar 2018 06:14:00 GMT

Solved
Turning off and starting the controllers in order, first the active controller and then the standby controller, the cluster has been configured ok and the error has disappeared. The simplest solution at the end is the most effective.
Thanks everyone
Regards.