topic Why rim process should be in high load ? in ExtremeWireless (WiNG)

Why rim process should be in high load ?

Aviv_Kedem — Sun, 19 Apr 2020 14:03:00 GMT

Hello community ,

Seen rim process in high load sometimes, even cause a triggering pm for restarting:

%DIAG-4-CPU_LOAD: 1 minute average load limit exceeded, value is 100.0% limit is 99.9% (top processes: rim using 24.9)

Distributed, l3 adoption with VX. In this site about 40 aps.

Any ideas why rim process should be in high load sometimes ?

Thanks,

Aviv

RE: Why rim process should be in high load ?

ckelly — Sun, 19 Apr 2020 23:39:00 GMT

Aviv, what version of WiNG?

There have been periodic issues in the past with some WiNG versions that might be explained by what you’re describing here, but need to know the version to see if there are any fixes mentioned in any of the Release Notes.

RE: Why rim process should be in high load ?

Aviv_Kedem — Tue, 21 Apr 2020 12:51:00 GMT

Hello Chris,

5.9.2.6

Thanks

Aviv

RE: Why rim process should be in high load ?

ckelly — Tue, 21 Apr 2020 21:17:00 GMT

Aviv, I can see that there are three RIM issues that were resolved in the WiNG 5.9.7 release.

I can’t tell if any of these three match with the problem that you are describing, but my recommendation (if not yet wanting to contact GTAC about this) is to take one AP and upgrade it with the 5.9.7 code and see if the problem is resolved. If it’s not, you’ll need GTAC’s assistance to analyze this.

RE: Why rim process should be in high load ?

Aviv_Kedem — Wed, 22 Apr 2020 04:12:00 GMT

Hello Chris,

Thanks a lot

Aviv