topic Re: AP-7522 Client Bridging Isn't Working - March 2019 in ExtremeWireless (WiNG)

AP-7522 Client Bridging Isn't Working - March 2019

Aaron_Wright — Tue, 26 Mar 2019 23:19:58 GMT

I've posted about this problem before and I'm having the same problem that I can't solve.

https://community.extremenetworks.com/extremewireless-wing-230514/ap-7522-client-bridging-isn-t-working-7815806/index2.html

I've upgraded both APs to 5.9.3

I have set up AP1 with ssid myWireless

I have configured AP2 with the following

en
config t
rf-domain default
country-code us
exit
profile ap7522 default-ap7522
interface radio 1
shut
interface radio 2
rf-mode bridge
bridge ssid myWireless
bridge encryption-type ccmp
bridge authentication-type none
bridge wpa-wpa2 psk 0 myWirelessKey
comm wr
self
interface vlan 1
ip address 192.168.1.82/24
exit
ip default-gateway 192.168.1.1
commit write

When I run "show wireless bridge candidate-ap" it shows "Total number of candidates displayed: 0"

Can anyone help me get this bridging configuration working?

Thank you

Re: AP-7522 Client Bridging Isn't Working - March 2019

Aaron_Wright — Tue, 26 Mar 2019 23:23:14 GMT

I have 2 antennas installed on both access points

I have verified that I can successfully connect to AP1 with my laptop and ping other devices on the 192.168.1.0/24 network

Re: AP-7522 Client Bridging Isn't Working - March 2019

Aaron_Wright — Tue, 26 Mar 2019 23:32:21 GMT

The APs are sitting right next to each other. AP1 is connected to the network with an Ethernet cable. AP2 is not connected with an Ethernet cable, I am configuring it through the console port.

Re: AP-7522 Client Bridging Isn't Working - March 2019

Aaron_Wright — Wed, 27 Mar 2019 03:32:51 GMT

I may have resolved this by enabling 5GHz on one of the antennas on AP1