topic Re: I can't see the web interface of an AP510i in standalone mode in ExtremeWireless (WiNG)

I can't see the web interface of an AP510i in standalone mode

jflores — Sat, 18 Jul 2020 09:25:19 GMT

I have an AP510i in standalone mode but I can't see the web interface to configure it.
This is the IP that I am connecting to according to the manual.

I already have connectivity between the laptop and the AP.

But when I try to infest from any browser, it throws the following error.

Does anyone know if I have to enable a service in order to manage the web interface.

Re: I can't see the web interface of an AP510i in standalone mode

Miguel-Angel_RO — Sat, 18 Jul 2020 14:30:54 GMT

Jesus,

This is certainly due to the fact that the AP has been preloaded with the LEAN firmware.

You must upgrade it with the full image to have a web UI interface.

Mig

Re: I can't see the web interface of an AP510i in standalone mode

jflores — Sun, 19 Jul 2020 02:16:47 GMT

Thank you very much Miguel, my question is going to sound very silly but how can I differentiate between the LEAN version and the STANDARD version. This is the version that my AP has.

Again, thank you very much.

Re: I can't see the web interface of an AP510i in standalone mode

Miguel-Angel_RO — Mon, 20 Jul 2020 00:21:43 GMT

Jesus,

It seems that you have the standard image deployed.

Check here:

https://gtacknowledge.extremenetworks.com/articles/Q_A/What-is-purpose-of-files-within-WiNG-firmware-package/

I’ll check that on my own AP.

Mig

Re: I can't see the web interface of an AP510i in standalone mode

Miguel-Angel_RO — Mon, 20 Jul 2020 02:03:55 GMT

Jesus,

I do have the same behavior after full reset.

I had no web access before.

I cannot have it adopted on the Clouc but well on an XCC.

Mig

Re: I can't see the web interface of an AP510i in standalone mode

Christoph_S — Mon, 20 Jul 2020 19:15:56 GMT

Hello Jesus,

As Mig said, you probably have a LEAN image on your AP. You cannot differentiate between the 2 once installed. I would recommend you upgrade to the latest 7.3.1.4 firmware and not reinstall the same version. Make sure you select the full and not the LEAN version.

Regards,

Chris

Re: I can't see the web interface of an AP510i in standalone mode

jflores — Tue, 21 Jul 2020 01:14:28 GMT

Thank you very much, update the firmware and you can manage it via the web.