https://community.extremenetworks.com/t5/extremewireless-wing/remove-wing-7522-from-virtual-controller-to-make-it-stand-alone/m-p/69464#M6269 For stand-alone mode, best to access the AP CLI (Command line interface) and perform the following:<BR /> <BR /> enable [enter]<BR /> self [enter]<BR /> no mint mlcp ip [enter]<BR /> no mint mlcp vlan [enter]<BR /> com write [enter] Tue, 29 Jan 2019 00:39:00 GMT Christopher_Fra 2019-01-29T00:39:00Z https://community.extremenetworks.com/t5/extremewireless-wing/remove-wing-7522-from-virtual-controller-to-make-it-stand-alone/m-p/69463#M6268 I have a Wing 7522 access point that I would like to make a stand alone device. How do I remove it from a 7522e virtual controller? I have reset the 7522 to factory defaults, but it still goes back on the virtual controller. Mon, 28 Jan 2019 23:27:00 GMT https://community.extremenetworks.com/t5/extremewireless-wing/remove-wing-7522-from-virtual-controller-to-make-it-stand-alone/m-p/69463#M6268 M__Lockwood 2019-01-28T23:27:00Z https://community.extremenetworks.com/t5/extremewireless-wing/remove-wing-7522-from-virtual-controller-to-make-it-stand-alone/m-p/69464#M6269 For stand-alone mode, best to access the AP CLI (Command line interface) and perform the following:<BR /> <BR /> enable [enter]<BR /> self [enter]<BR /> no mint mlcp ip [enter]<BR /> no mint mlcp vlan [enter]<BR /> com write [enter] Tue, 29 Jan 2019 00:39:00 GMT https://community.extremenetworks.com/t5/extremewireless-wing/remove-wing-7522-from-virtual-controller-to-make-it-stand-alone/m-p/69464#M6269 Christopher_Fra 2019-01-29T00:39:00Z