topic Re: Can we create multiples vlans for one single SSID. If yes please let me know the steps??? in ExtremeWireless (WiNG)

Can we create multiples vlans for one single SSID. If yes please let me know the steps???

Srinivas_K1 — Tue, 16 Jul 2019 17:28:57 GMT

In wing access points can we create multiple VLANS for one single SSID, if its possible please let us know the steps or if any documents available??

Re: Can we create multiples vlans for one single SSID. If yes please let me know the steps???

Christoph_S — Tue, 16 Jul 2019 19:15:50 GMT

Hello Srinivas,

This might help: https://gtacknowledge.extremenetworks.com/articles/Q_A/What-is-vlan-pool-member-command-good-for-in-WiNG-WLAN-configuration

Thank you,

Chris

Re: Can we create multiples vlans for one single SSID. If yes please let me know the steps???

Srinivas_K1 — Fri, 19 Jul 2019 14:31:50 GMT

Hi Chris,

I have checked the above link and i tried to create different vlans( vlan 10 and Vlan 20) in 8432 AP. I was able to create vlan pool I am getting IP address when connected to Vlan 10. But I am not getting the IP address when connected to other vlan 20..What will be the issue??

Re: Can we create multiples vlans for one single SSID. If yes please let me know the steps???

Christoph_S — Fri, 19 Jul 2019 20:04:25 GMT

Hello Srinivas,

First place to look would be the ge 1 interface. Check to make sure it's designated as trunk and that both vlans are allowed out. Also make sure that both vlans are allowed through the switchport the AP/s is/are connected to.

Thank you,

Chris

Re: Can we create multiples vlans for one single SSID. If yes please let me know the steps???

Srinivas_K1 — Tue, 30 Jul 2019 12:58:59 GMT

Hi Chris,

I have create ge1 as Trunk port and allowed both the vlans but I didn't understood your second statement
"Also make sure that both vlans are allowed through the switchport the AP/s is/are connected to"
plz let us know the next step..

Re: Can we create multiples vlans for one single SSID. If yes please let me know the steps???

Christoph_S — Tue, 30 Jul 2019 19:56:37 GMT

Hello Srinivas,

The AP's are connected to switches, so the same vlans already configured on the APs should also be allowed through those switches.

1 - Vlans allowed through AP ge 1 port which you did by setting it as trunk and allowing the vlans through
2 - Same vlans should be configured to allow traffic on the switches the APs are connected to.

AP ge1 trunk allowed vlans 1,2,3,4 <----------> switch allowed vlan 1,2,3,4

I hope this helps,

Chris

Re: Can we create multiples vlans for one single SSID. If yes please let me know the steps???

Srinivas_K1 — Wed, 31 Jul 2019 12:59:11 GMT

Hi Chris,

Thanks for your reply..