https://community.extremenetworks.com/t5/extremewireless-wing/nx-5500-cluster-fail-over-issues-tunneled-sub-interfaces/m-p/82492#M7622 Someone told me the config that is under the primary controller needs to be in a controller profile and tied to both units if this is the case can you please provide me the steps thank you. Tue, 05 Mar 2019 22:30:38 GMT OGB-NIKO 2019-03-05T22:30:38Z https://community.extremenetworks.com/t5/extremewireless-wing/nx-5500-cluster-fail-over-issues-tunneled-sub-interfaces/m-p/82491#M7621 During a cluster test fail over taking the master nx5500 controller offline i was unable to ping the tunneled interfaces on the secondary controller they did not come up.Can anyone tell me where i went wrong or what i am missing thank you. Tue, 05 Mar 2019 19:07:57 GMT https://community.extremenetworks.com/t5/extremewireless-wing/nx-5500-cluster-fail-over-issues-tunneled-sub-interfaces/m-p/82491#M7621 OGB-NIKO 2019-03-05T19:07:57Z https://community.extremenetworks.com/t5/extremewireless-wing/nx-5500-cluster-fail-over-issues-tunneled-sub-interfaces/m-p/82492#M7622 Someone told me the config that is under the primary controller needs to be in a controller profile and tied to both units if this is the case can you please provide me the steps thank you. Tue, 05 Mar 2019 22:30:38 GMT https://community.extremenetworks.com/t5/extremewireless-wing/nx-5500-cluster-fail-over-issues-tunneled-sub-interfaces/m-p/82492#M7622 OGB-NIKO 2019-03-05T22:30:38Z