https://community.extremenetworks.com/t5/extremewireless-wing/meshconnex-problem-with-configuration/m-p/84491#M7890 I have a similar issue.<BR /> <BR /> Is there any way to make AP7532 or AP722 to start a mesh connection with another AP only when ethernet link has been broken between the AP and the switch? Fri, 28 Jun 2019 03:00:22 GMT fserve 2019-06-28T03:00:22Z https://community.extremenetworks.com/t5/extremewireless-wing/meshconnex-problem-with-configuration/m-p/84490#M7889 Hi everyone,<BR /> <BR /> <BR /> I want one AP in the domain to connect clients being connected only to power. In research, I have seen that is possible with WING MESHCONNEX. However, I made the basic settings according to the functionality documentation, and this is not working. So far, the following settings have been made:<BR /> <BR /> 1 - Creating the Meshconnex policy <BR /> 2 - Inclusion of the policy in the profile of APs<BR /> 3 - inclusion of the policy in radio2 (5.0) in access points<BR /> <BR /> After that, I remove the network connection from one of the access points, and it becomes inoperative. Can I be forgetting some configuration?<BR /> <BR /> ps: in this domain there are 3 access points (2 AP7532 and one AP732), being one of the virtual controller APs for others, the version of wing used at the moment is 5.9.2.4<BR /> <BR /> sorry for my bad english, im from Brazil Fri, 28 Dec 2018 03:32:08 GMT https://community.extremenetworks.com/t5/extremewireless-wing/meshconnex-problem-with-configuration/m-p/84490#M7889 Matheus_Santana 2018-12-28T03:32:08Z https://community.extremenetworks.com/t5/extremewireless-wing/meshconnex-problem-with-configuration/m-p/84491#M7890 I have a similar issue.<BR /> <BR /> Is there any way to make AP7532 or AP722 to start a mesh connection with another AP only when ethernet link has been broken between the AP and the switch? Fri, 28 Jun 2019 03:00:22 GMT https://community.extremenetworks.com/t5/extremewireless-wing/meshconnex-problem-with-configuration/m-p/84491#M7890 fserve 2019-06-28T03:00:22Z