topic Re: CLI Command to reboot both NX5500 cluster 5.9.2 in ExtremeWireless (WiNG)

CLI Command to reboot both NX5500 cluster 5.9.2

OGB-NIKO — Wed, 24 Mar 2021 14:31:07 GMT

Does anyone know the CLI Command or step to reboot both NX5500 cluster version 5.9.2 gracefully

Re: CLI Command to reboot both NX5500 cluster 5.9.2

Christoph_S — Wed, 24 Mar 2021 19:15:02 GMT

Hello,

#reload

Related commands:

#reload ?
  DEVICE-NAME  Name/MAC address of device(s)
  at           Reload at a specific time on a date
  cancel       Cancel pending reload
  force        Force reboot ignoring conditions like upgrade in progress,
               unsaved changes etc
  in           Reload after a time interval
  on           On RF-Domain
  staggered    Reload of the APs in a staggered way

Is this what you are looking for?

Thank you,

Re: CLI Command to reboot both NX5500 cluster 5.9.2

OGB-NIKO — Wed, 24 Mar 2021 19:36:28 GMT

I want to reload/reboot both active and standby controllers either with command line or in the GUI do i do one unit at a time ?

Re: CLI Command to reboot both NX5500 cluster 5.9.2

Christoph_S — Wed, 24 Mar 2021 19:46:01 GMT

Yes, start by rebooting the Primary controller, all APs should fail over to the Standby controller. Once the Primary is back up, reboot the Standby controller and all APs should revert back to the Primary controller.

I hope this helps,

Re: CLI Command to reboot both NX5500 cluster 5.9.2

OGB-NIKO — Wed, 24 Mar 2021 20:40:04 GMT

So i just type the reload command and enter and then follow the rest of the steps above ?

Re: CLI Command to reboot both NX5500 cluster 5.9.2

Christoph_S — Wed, 24 Mar 2021 20:44:22 GMT

When you type #reload, you will be prompted to confirm the action. Type Y and the controller will reload. If the cluster is properly configured, all APs should fail over to the Standby controller. Once the Primary controller is back up, run the same command on the Standby controller and all APs should come back to the Primary controller while the Standby reboots.

Thank you,

Re: CLI Command to reboot both NX5500 cluster 5.9.2

OGB-NIKO — Wed, 24 Mar 2021 21:04:24 GMT

Excellent thank you Chris