topic Re: Can I have 2 WLC on the same VLAN by different WLC model and without cluster in ExtremeWireless (WiNG)

Can I have 2 WLC on the same VLAN by different WLC model and without cluster

Aroon_Thongyod — Tue, 10 Sep 2019 23:15:52 GMT

Hi all

Can I have 2 WLC on the same VLAN ?

WLC1 for old model such as 650,6511,6521

WLC2 for New model 76xx and higher

Will they do any disturb to system ? Should I separate them to different VLAN ?
Please suggest
Thank for your advance .

Re: Can I have 2 WLC on the same VLAN by different WLC model and without cluster

ckelly — Tue, 10 Sep 2019 23:20:16 GMT

If the two systems are not properly setup, they WILL be able to see each other (the MINT protocol used by the APs and controllers) and this can very likely cause issues. If you are able to separate the two networks completely by having them operate on non-overlapping VLANs, that should remove the risk. This would include all WLAN VLANs as well as management VLANs.

Re: Can I have 2 WLC on the same VLAN by different WLC model and without cluster

Aroon_Thongyod — Sat, 14 Sep 2019 16:01:12 GMT

Hi Kelly
Now I have some issues , RF Domain and some APs form WLC1 jump to WLC2

follow the picture the RED SQURE form WLC1

WLC1(RFS6000)firmware 5.8.4 VLAN :10 Uplink to switch config as trunk Native vlan 10

WLC2(NX5500)firmware 5.8.9 VLAN :11 Uplink to switch config as trunk Native vlan 11 allow 10

VLAN 10 use for WLC1 and switch management . T

Thanks in advance for any help that you are able to provide.

Re: Can I have 2 WLC on the same VLAN by different WLC model and without cluster

Tomasz — Fri, 20 Sep 2019 05:57:00 GMT

Hi Aroon,

Please review the switch side config for WLC ports (if native vlan is not tagged, proper native vlan/PVID should be set on the switch side as well) and for the APs meant to be used by those controllers. Or go to IP-based adoption for higher level of predictability if that might help.
Within a single VLAN maybe static adjustments of MINT Area-Id would help but that sounds like a hassle if it's possible to just separate the broadcast domains for one and another wireless mgmt/control plane.

Hope that helps,
Tomasz

Re: Can I have 2 WLC on the same VLAN by different WLC model and without cluster

Aroon_Thongyod — Tue, 15 Oct 2019 22:59:38 GMT

Hi all

Follow the pic

Vlan 10 for manage all devices WLC1,switch,server,pc etc...

WLC1(RFS6000)firmware 5.8.4 VLAN :10 Uplink to switch configured as trunk Native vlan 10

WLC2(NX5500)firmware 5.8.9 VLAN :11 Uplink to switch configured as trunk Native vlan 11 allow vlan10

Issue : I remove vlan 11 all switchs port that connect to WLC1 , But APs still adoption to WLC2

pleas see picture belew

MiNT information from APs leaked to WLC2 . I want kick them back to WLC1

MiNT infromation from APs on WLC2 (correct).