topic Re: Cannot Config New WLAN for AP7632 in ExtremeWireless (WiNG)

Cannot Config New WLAN for AP7632

Autobar — Sat, 02 Nov 2019 23:02:35 GMT

Hi,

We bought 7632 APs recently (WiNG v5.9).

The problem we face is about adding new configurations. As after default quick config wizard, the WLANs we add WLAN 1 and WLAN 2 with SSID of Autobar and AGS_Test, it is working and broadcasting.

But after that we try to add new WLAN i.e. Test with same SSID, it is not broadcasting though I copy it just from existing one and changed its name later, so every config is followed from already working configuration.

And for every new addition we have to factory reset and apply new WLAN during quick config Setup.

Re: Cannot Config New WLAN for AP7632

ckelly — Sun, 03 Nov 2019 00:16:39 GMT

It sounds like you are only creating the new WLAN (SSID) but not actually configuring the AP’s radio to *use* the new WLAN. It’s a two-step process.

Create a WLAN
Configure an AP Profile radio(s) to use the WLAN

Navigate to the AP’s Profile
Expand the Interfaces section
Select “Radios”
Edit radio1 and/or radio2 (double click on them)
Go into the tab at the top labeled “WLAN Mapping / Mesh Mapping”
Highlight the WLAN you want to use in the window labeled “WLANs” and then click on the < button to ‘put’ that WLAN in the Radio’s mapping window.
Click on OK to close that window
Repeat for the other radio if needed
Click on Commit and Save at the top right of the screen
You should immediately begin seeing the SSID in the air

Re: Cannot Config New WLAN for AP7632

Autobar — Sun, 03 Nov 2019 01:57:27 GMT

Done

Working

Thanks

Its like “Extreme Support” 🙂