topic Re: NX5500 Cluster Active Standby in ExtremeWireless (WiNG)

NX5500 Cluster Active Standby

OGB-NIKO — Thu, 13 Oct 2022 14:53:17 GMT

I currently have a NX5500 cluster in a active standby configuration we have been having issues where the active goes into a standby mode all on its own and i was told by the Extreme tech to change the vlan IP address on the standby controller so they do not match the active so when failover does take place we will no longer have conflicts. To do so will i need to break the cluster or just make the changes on the standbuy and reboot both units ? Any guidance is greatly apprecieated

Thank you

Re: NX5500 Cluster Active Standby

Christoph_S — Fri, 14 Oct 2022 15:28:51 GMT

Hi,

If you need help breaking and recreating cluster, please follow this link to instructions on same: https://extremeportal.force.com/ExtrArticleDetail?an=000081411

Don't forget to make sure that the cluster Master priority is set to 255 and the Standby to 128.

BR,

Re: NX5500 Cluster Active Standby

Christopher_Fra — Fri, 14 Oct 2022 15:32:55 GMT

Hello OGB-NIKO,

Both controllers require their own IP address at the device level, to avoid duplicate IP issues on wired network.

The following are Knowledgebase articles to assist you on the configuration.

How to disable and recreate a non-working cluster on WiNG controllers:

https://extremeportal.force.com/ExtrArticleDetail?an=000081411&q=Wing%20Cluster

How to configure a static or DHCP IP address to a WiNG AP or controller from CLI:

https://extremeportal.force.com/ExtrArticleDetail?an=000081413&q=Wing%20How%20to%20configure%20IP%20address

Thanks,

Chris Frazee

Extreme Networks