DFE Switch Won't Boot after 7G-6MGBIC(-A) is installed

FAQ_User — Tue, 26 Nov 2013 17:49:00 GMT

Article ID: 5216

Products
7G4280-19
7H4284-49
7H4382-25
7H4382-49
7H4383-49
4H4284-49
7G-6MGBIC
7G-6MGBIC-A

Changes
Installed 7G-6MGBIC(-A)

Symptoms
Expansion module not recognized
Uplink not being seen by local management
No connectivity through gigabit uplink
Continually reboots
"Empire Initialization Failed"
Won't boot
"Cnx Based Internal Serpentine 10/1000 Mbps PHY Lpbk"
"Function Name: lpbkDiag"

Cause
If a 7G-6MGBIC(-A) is improperly installed, a DFE switch either may not properly boot, or will not properly recognize the 7G-6MGBIC(-A) ports.

The following three sets of symptoms have been observed, though this should not be considered to be an all-inclusive list:

The host switch fully boots, but the 7G-MGBIC(-A) ports are not listed in the results of a 'show port' command, and they do not function.
The host switch enters a constant reboot cycle, with the error message Empire Initialization Failed
The host switch fails to fully boot, with the error sequence Running Initialization Diagnostics... FAILED. Device Name: Switch Ports Test Name: Cnx Based Internal Serpentine 10/1000 Mbps PHY Lpbk Test Result: Failed Function Name: lpbkDiag() Error Description: Timeout (loop=1, data=012, block=0, port=0, len=64). Ucast pkt count error on MAC 2, port 0 (Rx=0, Tx=0).

Solution
If any boot anomalies or 7G-6MGBIC(-A) functionality issues are seen, after recently installing a 7G-6MGBIC(-A) or its host DFE switch, check the installation of the 7G-MGBIC(-A):

Remove the DFE switch from the chassis (using proper removal procedure 5036)
Using ESD (electro-static discharge) precautions, examine the two rectangular black connectors where the 7G-6MGBIC(-A) connects electrically with the host switch's circuit board
Ensure that these connectors are fully engaged and locked
Ensure that the three securing screws are properly seated
Reinstall the DFE switch into the chassis

topic DFE Switch Won't Boot after 7G-6MGBIC(-A) is installed in FAQs

DFE Switch Won't Boot after 7G-6MGBIC(-A) is installed