SecureStack/G/D-Series f/w x.02.03 'show support' does not Display the Entire System Configuration

FAQ_User — Thu, 07 Nov 2013 22:39:00 GMT

Article ID: 11433

Products
SecureStack C3, firmware 1.02.01.0004 through 1.02.03.0012
SecureStack C2, firmware 5.02.01.0006 through 5.02.03.0012
SecureStack B3, firmware 1.02.01.0004 through 1.02.03.0012
SecureStack B2, firmware 4.02.01.0006 through 4.02.03.0012
G-Series, firmware 1.02.00.0043 through 1.02.03.0010
D-Series, firmware 1.00.03.0002 through 1.00.04.0001

Changes
Issued a 'show support' command (new as of f/w x.02) within a management session.

Symptoms
The command output, below the "support -> show config" header, displays either a prematurely terminated configuration or no configuration at all.

Solution
For the C3, upgrade to firmware 1.02.04.0005 or higher.
For the C2, upgrade to firmware 5.02.04.0005 or higher.
For the B3, upgrade to firmware 1.02.04.0005 or higher.
For the B2, upgrade to firmware 4.02.04.0005 or higher.
For the G-Series, upgrade to firmware 1.02.04.0005 or higher.
For the D-Series, upgrade to firmware 6.03.01.0008 or higher.

Release notes state, in the 'Firmware Changes and Enhancements' section:
11584 Corrected an issue with the "show support" command which prevented the switch configuration from being displayed in its entirety.

topic SecureStack/G/D-Series f/w x.02.03 'show support' does not Display the Entire System Configuration in FAQs

SecureStack/G/D-Series f/w x.02.03 'show support' does not Display the Entire System Configuration