DFE Netflow Not Working on Routed LAGs unless Physical Ports are Enabled

FAQ_User — Tue, 03 Dec 2013 00:29:00 GMT

Article ID: 11093

Products
Matrix N-Series DFE, firmware 5.31.17 through 6.02.03.0002

Changes
Configured Netflow reporting for LAG ports.

Symptoms
Netflow does not report on flows routed across a LAG port.

Solution/Workaround
Upgrade to firmware 6.02.05.0001 or higher.

Release notes state, in the 'Software Changes and Enhancements' section:NETFLOW
Netflow now always reports routed flows ingressing a LAG
port when the LAG port is enabled using the CLI command
"set netflow port enable". Previously you
needed to enable the underlying physical ports that were
members of the Link Aggregation Group.
Pre-upgrade workaround: Enable both the LAG port, and the underlying physical ports, in Netflow.

See also: 7202 and 7485.

topic DFE Netflow Not Working on Routed LAGs unless Physical Ports are Enabled in FAQs

DFE Netflow Not Working on Routed LAGs unless Physical Ports are Enabled