HI Frnds I have One Problem I want to Configure Stacking with Two 48 Switches of Model X 440-G-48t-10GE4 Switches.
I dont Have Stacking Cable
I want to Configure with Multi Mode Fiber Optic Patch Cord and Multi Mode Modules
It Is possible To Conf With MM Fiber Patch Cord and Module..?
please Tell Me How to Do with Those.
I Tried Below Steps But Only Master Switch only Activating
1. SW1- Enable Stacking-support
2. SW1- configure stacking-support stack-port all selection alternate
3. SW1- Saved and Rebooted
4. SW2- Enable Stacking-support
5. SW2- configure stacking-support stack-port all selection alternate
6. SW2- Saved and Rebooted
7. Connected Fiber Cable in SW1 49 Port and SW2 50 port
8. SW1- Enable Stacking
9. SW1- reboot stack-topology
But It Stacking Is Not Working..
The Above Procedure Is Correct If Not
Please Tell Me the Correct Procedure With Steps