Header Only - DO NOT REMOVE - Extreme Networks

2016-08-29: New GTAC Knowledge Articles August 21 - 27, 2016

  • 31 August 2016
  • 0 replies

Here are the new articles that were published August 21 - August 27 2016 in GTAC Knowledge:

Sunday, August 21, 2016:

Monday, August 22, 2016:
How to access the CLI of the switch that is manged by ExtremeCloud
How to use EXOS and IDM to see end-systems in Netsight without NAC
NAC - pre-registration vs self-registration
Defined, the UL Dropped Due to Rate Packets / Bytes, DL Dropped Due To Rate Packets/Bytes, DL Dropped Buffer Packets/Bytes, and DL Lost Retires Packets/Bytes from the Identify Gui -> Reports-> All Active clients report
Controller rebooted on 10.11 firmware when Access Points are approved or released to it in bulk
Wireless controller reboots with 10.11 firmware and Sensor core file is found in Tech Support file
C5210 controller reboots with Watchdog timeout and a snmpsubagent core file in the Tech Support
how to configure a client timeout on WM3000 series

Tuesday, August 23, 2016:
Can the K-Series Provide Information About Power Allocated and Power available via SNMP?
WS-AP3825i booting to boot mode when a long untermintated UTP cable is plugged into the console port
Can bgp-ipv4-rib-in-routes on the S-Series Be Increased?
How much ipv6 routes can fit in hardware on bd8900-XL blades when not using external tcam
Can i use SFP+ Module on X450G2-GE4 switches?

Wednesday, August 24, 2016:
How to Configure Policy Based Routing on an XSR
Client does not receive a DHCP address in 10.11.02 when Access Control is set to Deny
Can the B5 / C5 be managed by a routed interface?
Date and time is not maintained after rebooting of the 800-Series switch
Why does traffic stop passing after port security is configured
Two EXOS switches have the same hardware MAC address
Securestack switch on older code does not forward ip address to wireless client
Wireless Access Point Flexview no longer works with 10.x firmware on controller
How are XSR NIM Card Interfaces Numbered?

Thursday, August 25, 2016:
Access Points are not forming backup tunnel in HA pair
What EXOS platforms support egress ACLs?
How to upgrade FW using inventory manager
How to configure a BGP router reflector with next-hop-self for iBGP neighbor?
How to configure 800 Series swith to use an NTP server

Friday, August 26, 2016:
Windows only devices failing to authenticate
I-Series Industrial Switch Boot up issues when incorrect console cable connected
OneView: No data in the User Sessions tab
NAC: End Systems disappear periodically from NAC
Update to Firmware 8.42.xx fails with constant reboots
Error -11 writing Node Config to Flash logs seen while saving configuartion

Saturday, August 27, 2016:

0 replies

Be the first to reply!