Header Only - DO NOT REMOVE - Extreme Networks

2016-10-03: New GTAC Knowledge Articles September 25 - October 1, 2016

Here are the new articles that were published September 25 - October 01, 2016 in GTAC Knowledge:

Sunday, September 25, 2016:
How to change the support portal password?

Monday, September 26, 2016:
How To Configure PBR on EXOS for NAC Integration with Multiple NAC Servers Utilizing Flow Redirect
How To Translate 800-Series Configuration to EXOS CLI
How to Configure a Route-Map to Redirect Traffic marked with a ToS value on a Cisco Enterprise Switch/Router
Can the AP3825e and AP3825i be configured for the Country China
How many Multicast groups are supported in EXOS?
Is it necessary to have DNS lookup for the primary router?
EXT3-fs warning on different slots
Cannot Disconnect Telnet Session on S-Series
How to change port buffer size.

Tuesday, September 27, 2016:
Link Aggregation Control Protocol (LACP) Fallback Option

Wednesday, September 28, 2016:
How to add priority to ospf route
Can a Non-PoE Securestack be Upgraded to Support PoE?
MM-A (BDX-MM1) Module of a BDX8 Failed
S/K series Line card failure MiimTimeOut:soc_miim_read, timeout
Can MAC authentication be used when using a bridged at AP topology
Client stops receiving unicast traffic for a time whilst other clients on the same AP radio are still working
802.1x expired AD password reset problem

Thursday, September 29, 2016:
What does the Applications by WLAN on the IdentiFi Home screen report
How do I enable Application Visibility on an IdentiFi controller
Why won't Chromecast work on my network?
creating user account via CLI XML/SOAP fails
SNMP privacy decoder for the MD5 hashed encription word displayed
Is a WS-V2110-9xxx-S v9 Cloud License also Compatible with ExtremeWireless v10?
Will SSH is enabled by uploading the configuration file with ssh enable and ssh module installed on the switch?
AP3765i - Motorola MC9190 barcode scanners are unable to connect to 2.4 GHz radio after some uptime
Nihon Kohden ECG devices doesn't get IP address from the DHCP Server after Firmware upgrade
ACL-Manager in netsight not VRF-Aware
Why does OneView not show the device name in the alarms source column

Friday, September 30, 2016:
Where can I see ALL the AP's Uptimes?
What OIDs are used for Port Utilization so that I can poll this information using an NMS or MIB browser?
Multicast Imaging is too slow
Can switch create dynamic ARP entries for multicast mac adresses?
S-Series Blade reset with Received Interrupt error PB_IRR_ERROR_MEMORY0
IPv4 route not added. Hardware LPM Table full
After upgrading EXOS, GUI is Screenplay still instead of Chalet

Saturday, October 01, 2016:
What is the default behavior of "if" in access list

0 replies

Be the first to reply!